Precautions In Disassembly And Reassembly; Disassembly - Hitachi C 6SE Technical Data And Service Manual

8. PRECAUTIONS IN DISASSEMBLY AND REASSEMBLY

The disassembly and reassembly procedures for the Model C 6SE and C 7SE are essentially the same. The [ ]
numbers in descriptions below correspond to the item numbers in the parts list and exploded assembly diagram
for the Model C 6SE, and the < > numbers for the Model C 7SE. During disassembly and reassembly, and at all
times as well, sufficient care must be exercised in handling to ensure that there is no deviation in the flatness of
the bottom surface of the base and in its perpendicularity with relation to the saw blade.

8-1. Disassembly

Before disassembly, be sure to remove the TCT Saw Blade [14] <14> to
prevent damage to the teeth or personal injury.
(1) Removing the Safety Cover [6] <6>
Remove the Return Spring [7] <7> from the Safety Cover [6] <6>. Remove the three Machine Screws [11]
<10>, Bearing Cap [9] <9> and Safety Cover [6] <6>.
(2) Removing the Bearing Holder [4] <4>
Remove the two Seal Lock Flat Hd. Screws [5] <5> and remove the Bearing Holder [4] <4> together with the
Spindle and Gear Set [2] <2>.
(3) Removing the Spindle and Gear Set [2] <2>
Hold the Bearing Holder [4] <4> in a cylindrical jig with an inside diameter 49 mm, and remove the Spindle
and Gear Set [2] <2> from the Bearing Holder [4] <4> by pushing the end of the spindle.
(4) Removing the Armature [30] <29>
Loosen the Brush Cap [40] <39> and remove the two Carbon Brushes
[39] <38>.
Loosen and remove the three M5 x 45 Machine Screws [23] <22> to
separate the Housing Ass'y [25] <24> from the Gear Cover Ass'y [34]
<33>. The Armature [30] <29> can be removed by tapping around the
Housing Ass'y [25] <24> lightly with a wooden or plastic hammer. Be
careful not to tap the fan of the Armature [30] <29>.
(5) Removing the Base Ass'y [63] <62>
Remove the D6 x 30 Roll Pin [61] <60> to separate the Base Ass'y [63] <62> from the Gear Cover Ass'y [34]
<33>.
--- 5 ---
Push
Jig
49 mm
Fig. 2