Docomo Prime CA-01C Instruction Manual page 150

AT command
AT&W Stores the current settings.
AT DANTE Displays the FOMA terminal
signal reception level.
AT DGANSM= Sets the reject/permit mode
setting for the packet
incoming call. This
command is effective for
those incoming packet calls
after the setting command is
input.
Sets APN, which permits
AT DGAPL= [,cid]
incoming packet calls, by
using <cid> parameter
defined by
+CGDCONT
AT DGARL= [,cid] Sets APN, which rejects
incoming packet calls, by
using <cid> parameter
defined by
+CGDCONT
AT DGPIR= This command validates the
setting for notifying Caller ID
when sending/receiving
packet communication.
Even in the dial up network
setting, you can also add
186 (notify) or 184 (not
notify) to the access point
number. (p.27)
AT DRPW Displays the indicator value
of the receiving power of the
FOMA terminal.
AT+CAOC Inquires for the current
charge.
Outline
Only = 0 can be specified (can be omitted).
0 FOMA terminal signal reception level is displayed as
out of area.
1 FOMA terminal signal reception level is 0 or 1
bar.
2 FOMA terminal signal reception level is 2 bars.
3 FOMA terminal signal reception level is 3 bars.
= 0
= 1
= 2
AT DGANSM?
= 0
= 1 : Deletes the APN defined by <cid>
If <cid> is omitted, this will apply to all cid.
AT DGAPL?
= 0 : Adds the APN defined by <cid> to
= 1 : Deletes the APN defined by <cid>
If <cid> is omitted, this will apply to all cid.
AT DGARL?
= 0 : Uses APN as it is (initial value).
= 1 : Uses APN by adding "184". (Caller ID
= 2 : Uses APN by adding "186". (Caller ID
AT DGPIR?
39
Parameter/description
Disables the incoming call reject (AT
DGARL)/permit setting (AT DGAPL) (initial
value).
Enables the incoming call reject
setting.
Enables the incoming call permit
setting.
Displays the current setting.
Adds the APN defined by <cid> to
incoming call permission list.
from incoming call permission list.
Displays incoming call permission list.
incoming call rejection list.
from incoming call rejection list.
Displays incoming call rejection list.
is always not sent.)
is always sent.)
Displays the current setting.
Command execution example
AT&W0
OK
AT&W
OK
AT&W?
ERROR
AT&W ?
ERROR
AT DANTE
DANTE:3
OK
AT DANTE ?
DANTE:(0-3)
OK
AT DGANSM=0
OK
AT DGANSM?
DGANSM:0
OK
AT DGAPL =0,5
OK
AT DGAPL?
DGAPL:1
OK
AT DGAPL =1
OK
AT DGAPL?
OK
AT DGARL =0,5
OK
AT DGARL?
DGARL:1
OK
AT DGARL =1
OK
AT DGARL?
OK
AT DGPIR =0
OK
AT DGPIR?
DGPIR:0
OK
AT DRPW
DRPW:0
OK
AT DRPW=?
DRPW:(0-75)
OK
AT+CAOC
+CAOC:"000014"
OK