Table of Contents
Advertisement
Interface
Image sensor
Micro-SD
Factory Default Reset
2.1.2 I/O Control Instruction
Descriptions for I/O cable set:
Interface
DC Power Jack
DI/DO
User could adjust the sense manually.
User can insert a micro SD card into this slot for event recording.
This button is hidden in the pinhole. This button is used to restore the
all factory default settings. Sometimes restarting the camera will
resume the system to a normal state. If the system still got problems
after restart, user can restore the factory default settings and install it
again. To restore the device, please follow the steps below:
1. Unplug the power jack, then press and hold the reset button.
2. Power on the camera. Don't release the button during the system
booting.
3. It will take around 30 seconds to boot the camera.
4. Release the button (remove the pin from the reset hole). The
camera should now be back to factory default.
5. Login the camera using the default IP (http://192.168.0.20), and
username (admin), password (admin).
Restoring the factory default setting will lose all the
previous settings included IP address forever. User needs
to run the IPInstaller program to search the device and
configure it to let the device work properly again.
The input power is 12VDC.
That supplies the power to the Camera with the power
adapter included in the package. Otherwise, the improper
power adapter may damage the unit and result in danger.
Connect the power and the Ethernet with the camera. The four-color
wires are used for I/O connection. About I/ O setting.
12
Full HD Ultra-mini Vandal Dome
Description
Description
ICA-5250
Advertisement
Table of Contents
