Table of Contents
Advertisement
Full HD Ultra-mini Vandal Dome
ICA-5250
C. I/O PIN definition
• GND (Ground): Initial state is LOW
• DO (Digital Output): DC 5V
• DI (Digital Input): Max. 50mA, DC 5V
2. I/O Setup
A. Click I/O Setting from the system setup page via IE, and check "Out1" to enable I/O signal.
B. Output Test
After the external input and output hardware is installed, you can use the "Relay Out" bottom on
the live video page to test if DO / Relay Out works.
1) OnOff Switch mode:
Click "ON" and the camera will trigger the external output devise. For example, your alarm buzzer
will continuously ring. You can manually break off the output signal by clicking "OFF".
62
Advertisement
Table of Contents
