Pre-Survey Preparation - Topcon GR-3 Operator's Manual

Pre-survey
Preparation
Before beginning to survey with the GR-3 receiver, the following
software needs to be installed and configurations need to be applied:
Install receiver configuration software
See "Installing Topcon Software" on page 2-2.
Optional: install SD card and/or SIM card
See "Installing the Optional SD and SIM Cards" on page 2-7.
Charge the batteries
See "Charging the Batteries" on page 2-9.
Enable power source settings (either attached or external)
See "Power Management" on page 2-11 and "Powering the
Receiver" on page 2-14.
Configure the Bluetooth wireless technology module
See "Bluetooth Module Configuration" on page 2-23.
Collect almanacs and ephemerides (after first-time configuration
activities as described in Chapter 3)
See "Collecting Almanacs and Ephemerides" on page 2-26.
This chapter also discusses connecting batteries to the receiver,
connecting the receiver and a computer, and powering the receiver
using different sources.
P/N 7010-0736
Chapter 2
2-1