Setup And Survey - Topcon HiPer XT Operator's Manual

Setup and Survey

This chapter describes:
• Receiver setup
• RTK Base station setup
• RTK Rover setup
• Basic surveying with the HiPer XT receiver
The HiPer XT package use one receiver as the Base station and the
other as the Rover station.
Receiver Setup
NOTICE
NOTICE
Note that the UHF radio and the GSM radio do not work
simultaneously. Only one radio may be used at a time.
To set up the receivers, you must:
1. Configure the receivers as shown in Chapter 2.
2. Set up the Base and Rover stations. See "Step 1: Set up the
Receiver" on page 3-2.
3. Measure the antenna height. See "Step 2: Measure Antenna
Height" on page 3-2 for internal antennas.
4. Begin collecting data. See "Step 3: Collect Data" on page 3-4.
All receivers include an internal, micro-strip antenna able to capture
L1/L2 signals from GPS and GLONASS satellites.
P/N 7010-0713
Chapter 3
3-1