Canon GP160F Service Manual page 59

Image processor PCB input / output (2/2)
Document
scanner
M61
motor
CN1-1
Inverter printed
-2
circuit board
Scanner lamp
Speaker
Stamp
SL303
solenoid *1
DC power supply
PCB
DC controller PCB
FAX modem board *2
To the ADF relay
PCB
*1 This function only applies to units equipped with the ADF.
*2 Is only installed if the unit is equipped with a FAX function.
COPYRIGHT © 1999 CANON INC.
Download Free Service Manual at http://printer1.blogspot.com
J214-1
-2
-3
-4
-5
-6
An actual check is not possible, therefore an explan
J207
ation of the signal name has been omitted.
J211-1
-2
+24V
J219-1
When "0" , the SL303 is ON
-2
(the document is stamped)
STMP*
J209
An actual check is not possible, therefore an
explanation of the signal name has been omitted.
An actual check is not possible, therefore
J201
an explanation of the signal name has been omitted.
J202 An actual check is not possible, therefore
an explanation of the signal name has been omitted.
J205 Refer to the ADF service manual
Figure 2-502
CANON GP160 REV.0 FEB. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 2 BASIC OPERATION
Refer to P. 3-3
Refer to P.3-4
Image processor PCB
2-7