Canon GP160F Service Manual page 317

#1 SSSW-SW04 communications trouble remedy setting
SW Bit
No. No.
0 Reserved
1 CI signal frequency check
2 Number of protocol signal's final flag sequences 2
3 Reception mode after CFR signal transmission
04
Time for which low-speed signal is ignored after
4
CFR signal transmission
5 CI signal frequency check when PBX is set
6 CNG signal at manual transmission
7 CED signal at manual reception
[Bit 1]
Select whether or not to check the CI signal frequency upon automatic reception.
If "check" is selected, the upper and lower limits of the CI signal frequency will be
checked when a transmission arrives. The fax will switch to automatic reception only
when both signals are within the standard range.
[Bit2]
You can select the number of final flag sequences for the protocol signal (transmission
speed is 300 bps).
When the procedure signal sent out by this unit is not properly received by the destina-
tion machine, set the number to 2.
:
MEMO
Error codes for errors which occur upon transmission
##100, ##280, ##281, ##282, ##283, ##750, ##754, ##755, ##758, ##759, ##760,
##763, ##764, ##765, ##768, ##769, ##770, ##773, ##775, ##778, ##780, ##783,
##785, ##788
COPYRIGHT © 1999 CANON INC.
Download Free Service Manual at http://printer1.blogspot.com
Function
Table 13-506
CANON GP160 REV.0 FEB. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 13 TROUBLESHOOTING
Bit setting
1
Check Do not check
1
High-speed
High-speed
/ low-speed
1500ms 700ms
Check Do not check
Do not send Send
Do not send Send
0
13-83