Dc Controller Pcb - Canon GP160F Service Manual

C.

DC controller PCB

1) Remove the printer unit from the
main body (see page 9-19 for further
information).
2) Stand the printer unit in the same
way as depicted in Figure 9-516.
:
Caution
When standing the printer unit on a
desk or other furniture, please be
careful not to scratch the surface of
the furniture.
Also, before performing this step,
please spread out newspapers, etc.
to ensure the right side of the print-
er unit's exter nal cover is not
scratched.
Do not perform this operation on an
unstable surface. Stand the printer
unit on a horizontal surface, and
make sure that it cannot topple
over. Make sure to remove the car-
tridge prior to standing the printer
unit up.
3) Remove all connectors which are
attached to the DC controller PCB.
4) Remove the 4 installation screws [1].
5) Slide the DC controller PCB together
with the support plate upwards. Then,
pull it out towards the front.
COPYRIGHT © 1999 CANON INC.
Download Free Service Manual at http://printer1.blogspot.com
CANON GP160 REV.0 FEB. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 9 EXTERNAL/AUXILIARY MECHANISM
Figure 9-516
Figure 9-517
Slide
[1]
[1]
9-25