Removing The Coil Carrier; Main Power Components - Electrolux E36IC75FSS Service Manual

COMPONENT ACCESS AND SERVICE PROCEDURES
The photo in Fig. 24 shows the cooktop coil carrier after the controls, induction coils and insulation
pad have been removed. To separate the coil carrier from the induction module housings remove the
sixteen screws indicated by the arrows in the photo.
When reinstalling these screws use care not to overtighten and strip the screw receptacle in the
induction module housing.
Once the coil carier panel is removed lift off the insulation board (Fig 24A) that covers the induction
modules.
With the coil carrier panel and insulation board
removed the two induction modules and their various
power components and surrounding insulation can
be accessed (Fig. 24B).The module on the left side
controls the left side and center cook zones. The
module on the right side controls the two right side
cook zones.
From this point either of the induction power
generator boards can be removed or replaced as
well as the fi lter boards, cooling fans, heat sink
thermal cutouts and connecting wires and cables.
The photo below shows the Filter Boards, Power Boards and Fans as well as the routing of the
various connecting cables and wires as they appear when mounted in the housing.
NOTE: The illustration below may differ from later production components found in the fi eld.
Filter circuit board
for left and center
induction coils.
Cooling Fan
Generator circuit
board for left rear and
left front coils
Generator circuit
board for center
coil

Removing The Coil Carrier

Fig. 24

Main Power Components

3 Zones Module
Page 24
Fig. 24A
2 Zones Module
Fig. 24B
Filter circuit board for
right side induction
coils.
Cooling Fan
Generator circuit
board for right rear
and right front coils