Additional Failure Conditions - Electrolux E36IC75FSS Service Manual

Symptom or Failure
Pan does not heat up.
Individual buttons can-
not be used or cannot
always be used.
Cooking power too low
or cooktop shuts down
prematurely.
No Operation / Dead
"H" in display when
cooking zone is cold and
switched off.

Additional Failure Conditions

Control Display
Normal operation Pan too small for proper pan
detection and only works with
low power.
Flashing "F" and pan Pan not detected.
does not heat.
Induction Coil not correctly
connected or Induction Coil
open.
Distance between coil and
glass ceramic too large.
None Touch Control defect.
None Auto Shut Off Activated
None Fluids spilled or object lying on
control panel keypads.
-
Cookzone surface tempera-
None or " " Seen in
ture above 240°C (464°F).
Cook Zone display
May be caused by boil dry or
empty pan on cook zone.
Normal operation Ventilation Slots Obstructed.
Unsuitable pots (bottom bent)
Distance between coil and
glass ceramic too large.
Fan does not start.
No Display . Heat sink thermal cut out
No indicators light open* or unplugged.
when power is
applied. *If thermal cut out is open
check for proper operation of
cooling fan and possible vent
obstructions.
"H" Temperature sensor defect.
Possible Cause or
Condition
Page 32
Suggested Corrective Action
Use larger pan or this pan on a
smaller cooking zone. Refer to own-
ers guide for proper pan selection.
Check whether the pots or pans are
suitable for induction. Refer to own-
ers guide for proper pan selection.
Check the coil wire terminal con-
nections. Ensure that they are
properly connected and tightened.
Test continuity of coil (should be
less than 1Ω) .
Check whether the coil is properly
positioned and touching the glass
cooktop surface.
1. Follow instructions for proper use
of touch controls on page 16
2. Check wires and connectors.
3.Replace Touch Control.
Cooktop will automatically shut off
after 18 hours of continuous use.
Restart cooktop in normal manner.
Clean up spills or remove objects.
Restart cooktop in normal manner.
Remove Pan and allow cook zone
to cool.
Clear vent openings
Follow owners guide for proper pan
selection
Check whether the glass ceramic
was pushed down when being
screwed in position and the coil has
been correctly
positioned.
1. Check the fan for foreign objects,
remove these where appropriate.
2. If necessary, replace fan.
3 Replace power generator board.
4 Replace Filter Board.
1. Verify proper incoming power
supply.
2. Check connection of heat sink
thermal cutout.
3. Test cut out for < 1 Ω resistance.
Replace if open.
1.Test Coil RTD for approx. 1KΩ at
room temperature. Replace coil if
resistance is incorrect.
2. Replace power generator board.