Removing And Replacing The Oven Door - Electrolux EI30EF35JS Use And Care Manual

50
Care and Cleaning
Removing and replacing the
oven door
CAUTION
To prevent possible burns, do not attempt to
remove the oven door until the oven has
completely cooled.
IMPORTANT
The oven door is heavy. Be careful when
removing and lifting the door. Do not lift the
oven door by the handle.
To remove the oven door:
1. Open oven door completely (Figure 1).
2. Pull the hinge locks on both left and right
hinges down from the oven frame completely
towards the oven door (Figure 2). A tool such
as a small flat-blade screwdriver may be
required.
3. Firmly grasp both sides of oven door along the
door sides (Do not use the oven door handle).
4. Close the door to the broil stop position. The
oven door will stop into this position just before
fully closing.
5. With the oven door in the broil stop position
(Figure 3), lift and carefully pull the oven door
away from the oven frame. To avoid finish
damage, be careful not to allow the oven door
hinges to contact the oven front frame.
To replace oven door:
1. Firmly grasp both sides of oven door along the
door sides (Do not use the oven door handle).
2. Holding the oven door at the same angle as
the removal position (See "Removing the oven
door" section), carefully line up and insert both
door hinge arms between the pins located on
each side of the oven door frame (Figure 1).
3. With both door hinge arms in place, open the
oven door (Figure 2).
4. Push the door hinge locks up towards and into
the oven frame for both left and right oven door
hinges to the locked position (Figure 3).
5. Close the oven door.
Fig. 1
Fig. 2
about
10°
oven
door
hinge
Fig. 3
roller
pin
hinge
arm
Fig. 4