Table of Contents
Advertisement
before recording, if you want to confirm that you haven't. Peak meters read more-or-less independent of
frequency. You should aim for 0 dB recording level for all signals.
6. Modification
The following modifications require some soldering. Only attempt if you are experienced in using an iron on
PCBs. Otherwise, refer to qualified personnel. After modification the Dap Audio warranty becomes void.
Links should not be threaded into holes on the PCB. They should be soldered to the tinned areas around
the holes, and bowed slightly upwards in between.
Mono Channel Aux Send 2 > pre-fader
All mono channels Aux Sends 2 are post-fader. If you want to convert them, carry out the modification
described below to each mono channel you want to be altered. The right PCB area is indicated by the
yellow printing (see figures below).
1) Switch desk off and disconnect it from the main supply.
2) Cut the "post" track
3) Add in a "pre" link
Repeat for all mono channels you want to be modified.
11
Advertisement
Table of Contents
