Martin smartMAC User Manual page 49

Message

(Memory error)

(Onboard programming error)

(RAM error)

(Color wheel error)

(Gobo wheel error)

(Feedback error pan)

(Feedback error tilt)

(Feedback error pan/tilt)

(Pan time-out)

(Tilt time-out)

(Focus time-out)

(Head temperature error)

(Yoke temperature error)
 
-
(Driver error, drivers 1 - 7)

(Display programming error)
Appears when...
...the EEPROM memory cannot be read.
....there is a software programming error.
....there is a RAM error.
...there is a malfunction in the color wheel or
gobo wheel positioning system.
...the pan and/or tilt correction systems cannot
correct a loss of step (or there is a malfunction
in the pan/tilt monitoring circuit such as a
defective sensor). After a time-out, the head
stops in a random position.
...there is a malfunction in the position
indexing circuit for pan, tilt or focus. After the
time-out, the fixture will establish a
mechanical stop and continue to work,
although calibration will be imprecise.
...there is a malfunction in one of the
temperature sensing circuits.
...one or more motor drivers fail.
...there is a display error.
Table 6: Display messages
Display messages
What to do
Reset fixture.
If a pan/tilt error is displayed when you
attempt to reset the fixture, check that
the effects hatch is fully closed.
Upload new fixture software.
Contact Martin service personnel if
problem continues.
49