Table of Contents
Advertisement
Noise reduction mode
The noise reduction mode (
degrees of quiet operation:
• When set to
• When set to 'silent' mode (
noise.
mode overrides pan, tilt and effects speed settings entered elsewhere in the control menus.
Custom settings
The custom settings function
settings. The savable settings are DMX mode, pan/tilt speed, pan/tilt inverse and swap, display, DMX reset,
shortcuts, noise reduction mode and effects speed.
All settings can be returned to factory defaults using the
Readouts
Total hours of use
→
use (i.e. number of hours with power applied to the fixture). To return the resettable counter to zero, display
it and then press [Up] until the counter reads
the fixture was manufactured.
Lamp management
The smartMAC monitors lamp operation:
→
•
the number of hours the lamp has been on.
→
•
used as the basis for lamp lifetime warnings. It is set to 3000 by default but this can be changed via the
→
→
•
the number of lamp strikes (i.e. number of times the lamp is powered on).
To return a resettable counter to zero, display it and then press [Up] until the counter reads
The non-resettable counters display totals since the fixture was manufactured.
Lamp lifetime warnings
If lamp lifetime warnings are enabled by setting
• 200 hours before the lamp reaches the end of its expected lifetime, the Service LED lights yellow and
flashes in the display
• When the lamp reaches the end of its expected lifetime, the Service LED lights red,
flash in the display and power to the lamp is shut down.
The lamp's expected lifetime is set to 3000 hours by default. If a lamp with a different expected lifetime is
installed, change the lifetime via the
Lamp lifetime warnings are disabled by default.
Lamp explosion mode
If a lamp fails,
pan and tilt are locked and the fixture does not respond to DMX control. If
the fixture and do not operate it until you have checked the lamp and replaced if necessary. Pan and tilt are
released and DMX control is re-enabled when power is reapplied.
Temperature
→
→
, pan, tilt and effects obey their settings entered elsewhere in the control menus.
), pan, tilt and effects are set to slow movement in order to minimize
→
→
provides a resettable (
→
provides a resettable (
→
→
displays the expected total lifetime of the lamp in hours. This figure is
menu.
→
provides a resettable (
appears in the fixture's display and the fixture enters lamp explosion mode, in which
provides temperature readouts for the head and the main PCB in the base.
) setting gives two effect movement options that give varying
-
allows you to save and recall three sets of fixture
→
) and a non-resettable (
. The non-resettable counter displays total hours of use since
) and a non-resettable (
) and a non-resettable (
→
to
→
menu.
Setup
→
command.
) counter for hours of
) counter that display
) counter that display
.
:
continues to
is displayed, cut power to
19
Hide quick links:
Advertisement
Table of Contents
