Troubleshooting; Solution For "Winusb.dll Not Found" Problem - PP3DP UP! mini User Manual

8. Troubleshooting

Problem or
error message
No power
Extrusion head
platform fails to reach
operating temperature
Extrusion head is not
extruding
Cannot communicate
with printer
Others

Solution for "Winusb.dll not found" problem

If you encounter an error message "Winusb.dll not found", it is because that
the driver is properly installed. Please follow the steps below:
Option 1: Uninstall Older Driver and Install New Driver
1. Open Control Panel in Windows, go to the "System Properties" dialog box,
and select the "Hardware" page.
UP! mini 3D Printer User Manual
Verify power cord is securely plugged in.
or 1. Verify printer is initialized. if not, initialize the
printer
2. Heating block is damaged, replace it
Filament is stuck in the extrusion head. See 3.3.3
Maintain (Extrude)
The gap between bearing and filament feed rollers
is too wide.
1. Make sure printer is connected to a computer
via a USB cable.
2. Unplug the USB cable, then plug it in again.
3. Reset the printer, and power it off then power it
on.
4. Restart the computer
Contact Technical Support :
8. Troubleshooting
Solution
support@pp3dp.com
53