Model Removal - PP3DP UP! mini User Manual

5. Model Removal

1. After a print job finishes, printer gives off beeps, and nozzle and platform
are not long heated.
2. Remove the cell board from the print platform with the printed part
3. Gently slide the shovel, an accessory that comes with the machine, under
the printed model and slowly wiggle it back and forth to pry loose the
model. Remember to wear gloves during the whole time of printing,
because the board and the model maybe still hot.
TIP: It is highly recommended to avoid removing the model
with the cell board still on the print platform. Doing so is very
likely to cause whole platform unlevel, crash the print head
with the model, or get burnt by the hot nozzle. The simplest
and safest way is remove the model and cell board together,
then remove the model from the cell board..
UP! mini 3D Printer User Manual
5. Model Removal
43