Honda Jazz Owner's Manual page 337

07/09/12 09:54:15 32SAA650_337
Lights
4. Insert the socket back into the
headlight assembly. Turn it
clockwise to lock it in place.
5. Turn on the lights and check that
the new bulb is working.
6. Put the windscreen washer
reservoir back in place. Install the
holding clip. Lock it in place by
pushing on the centre.
334
Maintenance
Replacing a Front Position Light/
Side Turn Signal Bulb
HOLDING CLIP
1. If you are changing the bulb on
the left side, start the engine, turn
the steering wheel all the way to
the right, and turn off the engine.
If you are changing the bulb on
the right side, turn the steering
wheel to the left.
2. Use a flat-tipped screwdriver to
remove the two holding clips from
the inner fender.
SOCKET
BULBS
SOCKET
SIDE TURN SIGNAL
(For some types)
3. Pull the inner fender cover back.
4. Remove the socket from the
headlight assembly by turning it
one-quarter turn anticlockwise.
5. Pull the bulb straight out of its
socket.
Push the new bulb straight into
the socket until it bottoms.