Honda Jazz Owner's Manual page 335

07/09/12 09:53:53 32SAA650_335
Lights
HOLD-DOWN WIRE
SLOT
Push the electrical connector onto
9.
the tabs of the new bulb. Make
sure the hold-down wire locks in
place.
Turn on the headlights to test the
new bulb.
10. Put the inner fender in place.
Install the two holding clips. Lock
each clip in place by pushing on
the centre.
332
Maintenance
Replacing a Front Turn Signal
Light Bulb
(Left side)
HOLDING CLIP
1. Open the bonnet.
The front turn signal light is next
to the headlight bulb. Use a flat-
tipped screwdriver to remove the
holding clip from the cover and
pull out the cover.
BULB
SOCKET
2. Remove the socket from the
headlight assembly by turning it
one-quarter turn anticlockwise.