Honda Jazz Owner's Manual page 340

07/09/12 09:54:45 32SAA650_340
3. Pull the bulb straight out of its
socket.
Push the new bulb straight into
the socket until it bottoms.
4. Put the socket back into its hole in
the lens and turn it clockwise until
it locks.
5. Test the lights to make sure the
new bulb is working.
6. Put the side turn signal assembly
back into the body, rear first. Push
on the front edge until it snaps into
place.
Replacing a Rear Licence Plate
Bulb
1. Open the tailgate. Push the rear
licence light assembly toward the
right and pull it out of the tailgate.
2. Remove the licence light assembly
by squeezing the tabs on both
sides of the socket.
3. Pull the bulb straight out of its
socket. Push the new bulb in until
it bottoms in the socket.
BULB
4. Turn on the lights and check that
the new bulb is working.
5. Put the licence light assembly
back into the tailgate, the right
edge first. Push the assembly to
the left until it stops.
Maintenance
Lights
337