Cooling System; Adding Engine Coolant - Honda Jazz Owner's Manual

07/09/12 09:48:11 32SAA650_293

Cooling System

Adding Engine Coolant

RESERVE TANK
If the coolant level in the reserve
tank is at or below the MIN line, add
coolant to bring it up to the MAX line.
Inspect the cooling system for leaks.
The coolant you add should always
be a mixture of 50% antifreeze and
50% water. Never add straight
antifreeze or plain water.
290
Maintenance
Always use genuine Honda All
Season Antifreeze/Coolant Type 2.
This coolant is pre-mixed with 50%
antifreeze and 50% water. It does not
require any additional mixing. The
cooling system contains many
aluminium components that can
corrode if an improper antifreeze is
used. Some antifreeze, even though
labelled as safe for aluminium parts,
may not provide adequate protection.
MAX
If the reserve tank is completely
MIN
empty, you should also check the
coolant level in the radiator.
Removing the radiator cap
while the engine is hot can
cause the coolant to spray
out, seriously scalding you.
Always let the engine and
radiator cool down before
removing the radiator cap.
1. Make sure the engine and radiator
are cool.
2. Turn the radiator cap anticlock-
wise, without pressing down on it,
until it stops. This relieves any
pressure remaining in the cooling
system.
3. Remove the radiator cap by
pushing down and turning
anticlockwise.