Radio Key Programming - Ness R16 User Manual

progrAMMINg - rAdIo KEys
The R16 will accept up to 14 Ness Radio Keys to be used for remote control wireless Arming/Disarming
and Panic functions.
Radio Keys are programmed to one of the 15 user Slots with the easy to use radio 'learn' mode.
A user Slot can hold either a keypad code or a radio key code, not both. user Code 1, (the master
Code), is always a keypad code.
TO PROGRAM RADIO KEYS
ACTION
Press...
Press...
Numbers 2 to 15 on the display will show which
User Slots already contain Radio Keys, (if any).
Press... (2 - 15)
The chosen User Slot number will be flashing.
User Slots with Radio keys already programmed
will be on steady.
Press and hold the PANIC button for at least
8 seconds on the Radio Key to be programmed.
If the Radio Key was successfully programmed, you
will hear beep, beep + 3 beeps.
See Extra Options For Radio Codes on the next page
to program the behaviour of the Radio Key's Panic
button. Or skip to step 6 to leave the factory default.
(Panic button triggers Panic Alarm).
Go to step 2 of any other programming option
or press...
TO DELETE RADIO KEYS
To delete a Radio Key, press P10E, select the
User Slot to delete (2E-15E), then press P10E again.
EXAMPLE: To delete the Radio key programmed on
User Slot 2.
Press... P10E 2E P10E
26
[Master Code]
to exit program mode.
NESS R16 CoNTRol PANEl - uSER mANuAl
NOTE
Enters Program Mode.
The icon will turn on.
P10E is the option number for
programming Radio Keys.
Choose a User Slot to program a
Radio Key. Enter a user slot number
from 2 to 15 followed by the E button.
This transmits the 'Learn' message to
the R16 panel.
A long beep means the Radio Key is
already programmed to another User Slot.
The icon will turn off when .
you exit program mode.
The panel must be in Program Mode.