Disarming - Ness R16 User Manual

opErATIoN

DISARMING

To Disarm the system using the onboard keypad,
enter a valid user code, followed by the E key.
[User Code]
Sirens and strobe output, (if running), will be reset
on disarming.
When you enter the protected premises through
a delay zone, the keypad will sound continuous
beeps as a reminder to disarm. The panel must
be disarmed before the entry delay time expires,
otherwise the alarm will sound.
If using a Radio Key, you can disarm from
outside the premises without having to enter
any protected zones.
12
NESS R16 CoNTRol PANEl - uSER mANuAl
To Disarm the system using a Radio Key
press the OFF button.
x 1
If Siren Chirps have been enabled by
your installer, the strobe light output will
flash and the onboard siren will 'chirp' three
times to indicate successful disarming.
The factory default entry delay time is 20
seconds. This can be changed if necessary, see
the programming section in this manual.
If you make a mistake in entering your code,
press the E button and try again. Five incorrect
code attempts will cause an alarm.