Inserting And Deleting Instructions - Omron SYSMAC C20P Operation Manual

Inputting, Modifying, and Checking the Program
Bit Search
7–5–6

Inserting and Deleting Instructions

Key Sequences
Example
136
In PROGRAM mode, any instruction that is currently displayed can be de-
leted or another instruction can be inserted before it. These are not possible
in RUN or MONITOR modes.
To insert an instruction, display the instruction before which you want the new
instruction to be placed, input the instruction word in the same way as when
inputting a program initially, and then press INS and the down key. If other
words are required for the instruction, input these in the same way as when
inputting a program initially.
To delete an instruction, display the instruction word of the instruction to be
deleted and then press DEL and the up key. All the words for the designated
instruction will be deleted.
Note Be careful not to inadvertently delete instructions; there is no way to recover
them without reinputting them completely.
When an instruction is inserted or deleted, all addresses in Program Memory
following the operation are adjusted automatically so that there are no blank
addresses and no unaddressed instructions.
The following mnemonic code shows the changes that are achieved in a pro-
gram through the key sequences and displays shown below.
Section 7–5