If The Machine Does Not Start; If Water Does Not Drain; If Fuses Continually Blow; If Timer Rapid Advances Or Stops During Cycle - Wascom EMERALD W75ES Operating & Maintenance Manual

56
• Check that all tubing, piping and connections
are free from leaks.
• Wipe and clean the inside of the machine,
making sure that the control components are
protected from moisture and dirt during the
cleaning operation.
Trouble shooting

If the machine does not start

A Check the circuit breaker in the power line to
Fig.
the machine.
84
B Check the door lock, including cable.
C Check the glass cartridge fuses.
D Check for loose wires at main power terminal
block.

If water does not drain

A Check the drain valve for clog. Check the
Fig.
drain solenoid (located next to the water
85
valves) for proper operation.
B Disconnect the drain hose connected to the
main drain line. If a full flow of water comes
out, the problem is in the main drain line. If
water flow is slow, the problem is a clog
between the drain valve and the drum. Clean
out the drain valve completely, including the
rubber boot at the top of the drain valve.

If fuses continually blow

A Check the door lock, including cable
B Check for short circuit.

If timer rapid advances or stops during cycle

A Check the door lock, including cable.
Trouble shooting
84
B
C
85
A
A
1208
B
1209