Fault-Finding Program - Wascom EMERALD W75ES Operating & Maintenance Manual

Fault-finding Program

If there is a power failure the washer will
remember the selected cycle for about 8 -10
minutes. The cycle will restart automatically when
power is restored.
Certain faults are automatically detected and
Fig.
indicated by a number code shown in the
Information Display .
36
For fault codes 01 and 02 restart may be
attempted after the fault has been corrected. For
all other faults power to the washer must be
turned off and on again before the washer can be
restarted.
If fault codes 03-09 appear, contact authorized
service personnel.
Fault Code Cause of fault
01 Water level too low. Open water
taps. Check level control.
Check drain valve for leak.
02 Door lock fault. Open and lock
door again. Replace if necessary.
03 Break in or to temperature sensor.
04 Short-circuit in or to temperature
sensor.
05 Water in drum at start of cycle.
Clogged drain valve or drain line.
06 Software error. Try again or call
Wascomat.
07 Not used.
08 Too much water in drum at start of
an extraction. Clogged drain valve
or drain line.
09 Not used.
Fault-Finding Program
36
21
1026