Built-In Service Program; Setting Service Switch - Wascom EMERALD W75ES Operating & Maintenance Manual

22

Built-in service program

A service program has been built into the
washer. This program should only be used by
qualified service personnel.

Setting service switch

• Remove the washer top cover.
• Move the service switch to the service
program position. (The switch is located on
Fig.
top of the circuit board next to the ribbon
37
connector).
This transforms the buttons into a numerical
keypad. Numbers 1-7 are on the wash cycle
Fig.
buttons, the Extra Extract button is 8 and the
38
Gentle Wash button is 9. The START button
serves as an ON/OFF switch.
NOTE:
When in service program the number 0
does not exist. Numbers used are 11-19,
21-28 etc.
Built-in service program
37
38
1476
ON/OFF
1037