Water level controls
Fig.
One pressure switch is used to control the correct water levels
during various cycles of the washing program.
71
Adjustment
All pressure switches are factory-calibrated to meet specific
requirements. The trip level for any one pressure switch can be
changed only within narrow limits because each trip range requi-
res a different set of springs. Call Wascomat's Service Depart-
ment at 516-371-0700 before attempting to adjust the level
control!
Water level
As a guide for checking the level control for proper functioning, the
normal level should be approximately at the bottom of the door
glass. It is primarily the reverse-wash mechanical action of the
washer which gets clothes clean, not the level of water or amount
of detergent. The water levels are set at the factory to get a full
load clean without wasting a drop of water, to save you money
and protect the environment.
71
Mechanical and electrical design
49
1158