Function Control Check-Out List - Wascom EMERALD W75ES Operating & Maintenance Manual

14

Function control check-out list

In the cylinder you will find the warranty registra-
tion card, a copy of the warranty policy, the bolt-
hole template, wiring diagram, and other perti-
nent material. The warranty card must be com-
pleted and sent to Wascomat immediately or
your warranty coverage will start from the day we
shipped the washer from our warehouse. All
other items should be placed in a safe place for
future reference.
The machine should be cleaned when the instal-
lation is completed, and checked out as detailed
below without loading the machine with clothes:
1. Check the incoming power for proper voltage,
phase and cycles.
2. Open water taps to the machine.
3. Turn on electric power.
4. Check the door lock as detailed in this
manual.
Fig.
5. Select the Warm cycle and then press the
20
START button.
6. Run through a complete Warm cycle, check-
ing for proper water temperature, drain opera-
tion and extract direction. To rapid advance
the timer, press and hold down the START
button until the indicator arrows reach the
desired part of the cycle.
Fig.
7. Now select and run the Cold cycle. There is
21
no hot water in the Cold cycle so if hot water
Fig.
enters the hoses are improperly connected.
22
Reverse the hot and cold water hoses.
8. The drum must extract in a counter-clockwise
Fig.
direction as seen from the front! If it does not,
23
reverse incoming electric lines L1 and L3.
NOTE:
All machines are factory tested prior to
shipment. Occasionally, some residual
water may be found when the machine is
installed.
Installation
20
21
22
23
1295
1835
1836
0958