Hot; Wash Cycles - Wascom EMERALD W75ES Operating & Maintenance Manual

Hot

Fig. After the machine has started and the door
automatically locked, the drain valve will close
52
and the hot and cold water valves will open to fill
the machine with mixed hot and cold water to the
level determined by the level control. At the same
time detergent from compartment 1 is mixed with
the incoming water.
When this level is reached, both water valves will
close. During filling and then through the wash
program the drum has a reversing rotation.
At the end of the prewash, the drain valve will
open, whereafter hot water will fill to the level
determined by the level control. At the same time
detergent from compartment 2 is mixed with the
incoming hot water.
The water level controlled machine will now wash
the fabrics for 6 minutes. The machine is then
emptied.
Hot and cold water are filled to the medium level
for the first rinse which lasts one minute, followed
by spin extraction for 30 seconds. After the
extraction comes the second rinse in cold water,
ending with extraction, whereafter the third rinse
is started. Fabric softener is automatically
admitted during the third rinse. The fabrics are
rinsed in cold water for two minutes followed by a
extraction of four minutes duration. Finally there
is a shake out for half a minute.

Wash Cycles

52
Time Temp.
(Min.)
Prewash 3
Detergent 1
Drain 0.8
Mainwash 6
Detergent 2
Drain 0.8
Extraction 0.5
Rinse 1 1
Drain 0.8
Extraction 0.5
Rinse 2 1
Drain 0.8
Extraction 0.5
Rinse 3 2
Detergent 3
Drain 1
Extraction 4
Shake-out 0.5
Total time 23
(water fill time
not included)
31
HOT
Warm
Hot
Warm
Cold
Cold
1203