(PZ50GT/PZ50FX/PZ50M/PZ50VT/PZ50MP)
È
3
É
3
DRIVE/REVERSE SELECTING SYSTEM
L/B Br/R
Sb
1
2
L/B Br/R
Sb
4
5
8-57
GEAR MOTOR
1. Remove:
• Gear motor
Refer
to
"SECONDARY
REVERSE GEAR CASE" in CHAPTER 4.
NOTE:
Since the pinion gear is in the drive position when
the gear motor is removed, be sure to perform the
reverse position inspection first.
Reverse position inspection steps È:
• Connect the battery (12 V) to the gear motor
terminals as shown.
Positive battery terminal → Sky blue 1
Negative battery terminal → Blue/Black 2
• Check that the pinion gear 3 turns clockwise.
Incorrect → Replace the gear motor.
NOTE:
The pinion gear should rotate clockwise and stop in
the reverse position.
Drive position inspection steps É:
• Connect the battery (12 V) to the gear motor
terminals as shown.
Positive battery terminal → Brown/Red 4
Negative battery terminal → Sky blue 5
• Check that the pinion gear 3 turns counter-
clockwise.
Incorrect → Replace the gear motor.
NOTE:
The pinion gear should rotate counterclockwise and
stop in the drive position.
2. Install:
• Gear motor
Refer
to
"SECONDARY
REVERSE GEAR CASE" in CHAPTER 4.
–
+
ELEC
SHAFT
AND
SHAFT
AND