Installation - Yamaha PZ50W Service Manual

SECONDARY SHAFT AND REVERSE GEAR CASE
1
1
2
3
1
a
b
2

INSTALLATION

1. Install:
• Secondary shaft assembly
Installation steps:
• Install the secondary shaft assembly.
• Install the secondary shaft assembly bolts 1.
• Install the bearing holder bolts 2.
• Tighten the secondary shaft assembly bolts 1.
• Tighten the bearing holder bolts 2.
• Tighten the set bolts 3.
2. Install:
• Shift arm
• Gear motor
Installation steps:
• Check that the gear motor is in the drive posi-
tion.
a
Refer to "GEAR MOTOR" in CHAPTER 8.
• Install the shift arm 1 onto the gear motor,
making sure that the center of the projection a
on the shift arm is within the range shown in the
illustration.
• Slide the shift fork 2 toward the middle shaft,
making sure to fit the projection a on the shift
arm into the slot b in the shift fork.
• After installing the shift arm and gear motor,
turn the secondary shaft by hand and check that
the middle shaft turns in the same direction.
4-29
POWR
TR
Secondary shaft assembly bolt:
10 Nm (1.0 m · kg, 7.2 ft · lb)
Bearing holder bolt:
24 Nm (2.4 m · kg, 17 ft · lb)
Set bolt (secondary shaft):
9 Nm (0.9 m · kg, 6.5 ft · lb)
®
LOCTITE