Yamaha PZ50W Service Manual page 405

PZ50/PZ50GT/PZ50FX/PZ50M
1 Corrugated tube (engine stop
switch lead, throttle switch lead,
right grip warmer lead, and
thumb warmer lead)
2 Right grip warmer lead
3 Right handlebar switch
4 Route the throttle cable over the
handlebar.
5 Multi-function meter unit lead
6 Parking brake cable
7 Route the brake hose over the
top rod of the windshield bracket.
(Except for PZ50)
8 Route the parking brake cable
between the top and bottom rods
of the windshield bracket.
(Except for PZ50)
9 Route the left handlebar switch
leads behind the handlebar.
0 Brake master cylinder
A Left grip warmer
B Brake light switch
C Corrugated tube (left grip warmer
lead, grip/thumb warmer adjust-
ment switch lead, brake light
switch lead, and headlight beam
switch lead)
D Auxiliary DC jack (PZ50GT/
PZ50FX/PZ50M)
E Rectifier/regulator
F Cylinder identification sensor
coupler
G A.C. magneto coupler
H Speed sensor lead
I Pressure regulator hose
J Fuel tank breather hose
K Throttle body heater hose
L Throttle position sensor
M Fasten the A.C. magneto lead,
oil pressure switch lead, and
pressure regulator hose with the
holder.
N Knock sensor
O Fasten the A.C. magneto lead,
water pump outlet hose, and
knock sensor lead with the plas-
tic band.
CABLE ROUTING
9-52
SPEC