Location To A Memory Point; Location To The Next Or Previous; Cue/Memory Point Using The Skip Mode (Skip Locate Function) - Fostex DV40 Operation Manual

• Location to a MEMORY point

By specifying a desired MEMORY point memory (among 04 through 99), you can locate to the
point.
1. When the recorder is stopped, press the [MEMORY] key.
The display shows a MEMORY point time with the flashing point number.
2. Use the jog dial to select a desired MEMORY point number (between "04" and "99") and press the
[LOCATE] key.
The recorder locates to the MEMORY point and the display returns to the Normal screen.
If you select a MEMORY point which does not hold time data, "--H--M--S--F--SF" is shown on the display.
Tips:
You can edit the time shown on the display after carrying out step 1 above. By pressing the [LOCATE]
key after editing the time, you can locate to the edited time. See "Chapter 6: Storing time data" for details
about how to edit time data.
• Location to the next or previous CUE/MEMORY point using the skip mode
(Skip locate function)
By setting the "Skip Mode?" menu in the Setup mode appropriately, you can locate to a CUE or
MEMORY point quickly.
1. Set the "Skip Mode?" menu in the Setup mode to "CUE" or "MEM".
The "Skip Mode?" menu is initially set to "FILE". See "Chapter 11: Setup mode" for details.
2. Press [SKIP/CURSOR] << or >> key.
Each time you press the key, the display shows something like the examples below and the recorder locates
the next or previous locate point (CUE or MEMORY point depending on the selection in step 1).
• If the skip mode is set to "MEM":
ABS
MEMORY
• If the skip mode is set to "CUE":
ABS
MEMORY
<Notes for location to a MEMORY point>
You can locate (including the skip locate function) to a desired time assigned to any of MEMORY points 04
through 99.
MEMORY points holding time data can be used in common by all audio files, however, you cannot locate
to a MEMORY point which holds a time greater then the REC END time (except for "Tape mode" files).
If you are going to locate to a such point, the display shows "Out of Zone!" and the operation is ignored.
In the following example, if file 02 is currently selected, you cannot locate to MEMORY 07 or 08.
In other words, you can locate to MEMORY points 04 through 06 and 09 through 11. If file 02 is currently
selected, you can locate all MEMORY points 04 through 11).
H
ABS
MEMORY
H M S F SF
H M S F SF
Mem 04
File 01
Mem 09 Mem 10
File 02
7-5
M S F SF
Flashing
or
H M
ABS
MEMORY
or
H M
ABS
MEMORY
Mem 05 Mem 06 Mem 07
Mem 11
S F SF
S F SF
Mem 08