Loading Setup Data - Fostex DV40 Operation Manual

4. After entering a desired name, press the [ENTER/
YES] key.
"Sure?" flashes on the display.
SETUP
5. Press the [ENTER/YES] key again.
The unit immediately saves the name and shows
"Completed!", followed by "User Setup Save?".
SETUP
SETUP
6. To exit the Setup mode, press the [EXIT/NO] key
(or the [STOP] key).

• Loading setup data

You can load a setup data box from among the default
box (Box number 0) and user boxes (Box numbers 1
through 9) which holds data you saved.
Tips:
Normally, when making recording in the NEW FILE
mode or creating a new audio file in the file select
mode, the setup data of the file previously selected
is copied to the new file.
Therefore, if you want to work with the new file
with a desired setup data set saved in a box, load
the box after creating the file.
1. Select "User Setup Load?" and press the [ENTER/
YES] key.
"BoxNo0" is shown where "0" is flashing.
You can now select a desired box by using the jog dial
(or the [>>|]/[|<<] keys).
If you select "BoxNo0[Default]", the default settings will
be loaded.
If you select any of User Boxes, an appropriate user
setup data set is loaded.
SETUP
SETUP
Flashing
Flashing
Flashing
Flashing
11-7
2. Select a desired box and press the [ENTER/YES]
key.
"Sure?" flashes on the display ("*" shows the selected
box number).
SETUP
5. Press the [ENTER/YES] key again.
The unit immediately loads the data and shows
"Completed!", followed by "User Setup Load?".
SETUP
SETUP
6. To exit the Setup mode, press the [EXIT/NO] key
(or the [STOP] key).
Flashing
Flashing