Selecting Loaded Wav File; Continuous Wav Files Playback Using List Play Function - Fostex DV40 Operation Manual

• Selecting loaded WAV file

A loaded WAV file can be optionally selected using a "FILE SELECT" function.
1. In the condition that a WAV file is recognized, press the [FILE SEL] key.
The file number of the recognized WAV file flashes ("001" in the example below). Rotating the
JOG dial lets you select a desired WAV file.
2. Select a desired WAV file by the JOG dial and press the [ENTER/YES] key.
The selected WAV file is displayed and is reproduced by the press of [PLAY] key.
Tips:
If the selected WAV file condition differs from the [TR MODE] SW / [AUDIO FILE] SW / [SAMPLING
FREQ] SW positions on the DV40 front panel, the mismatched segments flash on the display.

• Continuous WAV files playback using LIST PLAY Function

Loaded multiple WAV files can be continuously played back by linking Song (the order of file number)
or LTC recorded in each WAV file. (Refer to the owner's manual page 11-2 for "LIST PLAY" function in
detail.)
<NOTE>
Only the WAV files with the same Track mode and FS can be linked.
In order to link multiple WAV files by LTC, LTC must be recorded in the WAV files. If there is a gap of
LTC address between files, " <<Silent Area!>> " is displayed and no signal is output.
1. When the unit is in STOP mode, press the [LIST PLAY] key.
The display changes to the LIST PLAY mode select condition. In the default setting , "LTC_Link" is
displayed and "01" flashes. Rotating the JOG dial lets you select the other LIST PLAY mode "SongLink".
2. Select a desired LIST PLAY mode and press the [ENTER/YES] key.
If the "<<Wait!>>" message disappears, linking the WAV files is completed and the first linked WAV
file is displayed.
3. Press the [PLAY] key.
Continuous playback based on the LIST PLAY mode gets started.
DV40 Owner's Manual (Version V1.2 Supplement>
LTC IN
H M S
29
F
PGM
PGM
NEXT
Flashing
Flashing