JVC GR-DVM76 Instructions Manual page 87

40. Picture does not appear on the
LCD monitor.
41. Images on the LCD monitor
are jittery.
42. The LCD monitor, the
viewfinder and the lens have
become dirty (ex. fingerprints).
43. Time code does not appear.
44. An unusual mark appears.
45. An error indication (E01, E02
or E06) appears.
46. An error indication (E03 or
E04) appears.
40. • The viewfinder is pulled out.
• The LCD monitor's brightness
setting is too dark.
41. • The speaker volume is too
great.
42.
—
43. • "TIME CODE" is set to
"OFF".
44.
—
45. • A malfunction of some kind
has occurred. In this case the
camcorder's functions
become unusable.
46. • A malfunction of some kind
has occurred. In this case the
camcorder's functions
become unusable.
40. • Push the viewfinder back in.
• Adjust the brightness of the
LCD monitor. (
• If the monitor is tilted
upward 180 degrees, open
the monitor fully. (
41. • Turn the speaker volume
down. ( pg. 22)
42. • Wipe them gently with soft
cloth. Wiping strongly can
cause damage. (
43. • Set "TIME CODE" to "ON".
( pg. 38, 49, 52)
44. • Check the section of the
manual that explains LCD
monitor/viewfinder
indications. ( pg. 96 – 99)
45. • Remove the power supply
(battery pack, etc.) and wait a
few minutes for the
indication to clear. When it
does, you can resume using
the camcorder.
If the indication remains
even though you repeat the
above two or three times,
please consult your nearest
JVC dealer. Do not eject the
cassette. This will cause
damage to the tape.
46. • Eject the cassette once and
re-insert it, then check if the
indication clears. When it
does, you can resume using
the camcorder.
If the indication remains
even though you repeat the
above two or three times,
please consult your nearest
JVC dealer.
87
EN
pg. 13)
pg. 13)
pg. 91)