JVC GR-DVM76 Instructions Manual page 6

6
EN
How To Attach The Grip Belt
NOTES:
It is recommended to use the finger support so that
the tally lamp or the flash is unobstructed with
your fingers.
The grip belt can be attached to the camcorder
even if the finger support is not used. Be careful
not to cover the tally lamp or the flash when
holding camcorder without finger support.
1) Thread the finger support with the end of the strap
g.
2) Thread the loop end g through the eyelet a, then
pass the other end of the strap h and the pad
through the loop end h.
a
3) Thread the end of the strap h through the eyelet
b.
b
g
h
g
h
4) Thread the end of the strap through the buckle c.
Open the pad and fold the end of the strap h in
the pad. Then fold the pad.
5) Adjust the grip. (
c
pg. 12)