JVC GR-DVM76 Instructions Manual page 75

Select Scenes
Remote sensor
FADE/WIPE
EFFECT
EDIT IN/OUT
6
Point the remote control at the camcorder's
remote sensor. Press PLAY (U) and then press
R.A.EDIT ON/OFF on the remote control.
The Random Assemble Editing Menu appears.
Selected parameter
N I OUT
1 – – – – : – – ~
2 ~
3 ~
4 ~
5 ~
6 ~
7 ~
8 ~
T I ME CODE – – : – –
TOTAL 0 0 : 00
7
If using a Wipe/Fader at the beginning of the
scene, press FADE/WIPE on the remote control.
Cycle through the effects by pressing
repeatedly, and stop when the one you want is
displayed.
8
At the beginning of the scene, press EDIT IN/
OUT on the remote control. The Edit-In position
appears in the Random Assemble Editing Menu.
9
At the end of the scene, press EDIT IN/OUT. The
Edit-Out position appears in the Random
Assemble Editing Menu.
10
If using a Wipe/Fader at the end of the scene,
press FADE/WIPE.
PLAY
R.A.EDIT
ON/OFF
CANCEL
Random Assemble
MODE
Editing Menu
Cycle through the effects by pressing
repeatedly, and stop when the one you want is
displayed.
If you select a Wipe/Fader effect for an Edit-Out
point, the effect is automatically applied to the
following Edit-In point.
When you use Wipe/Fader effects, that time is
included in the total time.
11
If using Playback Special Effects, press EFFECT.
( pg. 69)
12
Repeat steps 8 through 11 to register
additional scenes.
To change previously registered points, press
CANCEL on the remote control. The registered
points disappear, one at a time, from the most
recently registered point.
If you are not using Wipe/Fader or Program AE
with special effects, repeat steps 8 and 9 only.
NOTES:
When choosing a scene, set Edit-In and Edit-Out
points so that there is a relatively large difference
between them.
If the search time for an in-point exceeds
5 minutes, the recording deck's Record-Standby
mode will be cancelled and editing will not take
place.
If there are blank portions before or after the Edit-
In and Edit-Out points, a blue screen may be
included in the edited version.
Since time codes register time only as accurately
as seconds, the time code total time may not
match the total program time exactly.
Turning off the camcorder's power erases all
registered Edit-In and Edit-Out points.
If you select Sepia or Monotone mode from
Program AE with special effects, you cannot use
the Black & White Fader. In this case the Black &
White indicator begins blinking. Once the next
Edit-In point is registered, the effect is turned off.
To combine these effects, use Sepia or Monotone
during recording, then use the Black & White
Fader during Random Assemble Editing.
It is not possible to use Wipe/Fader effects and
Program AE with special effects during Random
Assemble Editing using a DV cable.
CONTINUED ON NEXT PAGE
75
EN