Using Remote Controller; Starting Operation - Hitachi EP-A5000 Instruction Manual

Using Remote Controller

Here we describe how to operate the air purifier using the remote controller. For the operation using
the control on the purifier, please refer to page E-13.
Remote Controller
On/Off Mode Airflow
Timer
Sensor
Max
Setting
Securely insert the power plug
into AC outlet.
On/Off
Press
Operation starts and the indicators are lit.
On/Off
Pressing
operation will stop the operation.
*
The factory setting is "Air Purify".
From the second time onward, the memory function enables the operation with memorized conditions.
Stand-by Power Consumption
So long as the power plug is left inserted in AC outlet, approx. 3W power will be consumed even if the unit
is not used. (Unplug the power cord when the unit is left unused for an extended period of time.)
E-10

Starting Operation

Air Purifier
button.
button during
Indicator Section
Humidity Level
Strong
(Green) Auto
Air Purify Pollen Deodorization
(Orange) Humidify Skin
Timer (4hrs)
Moisturize
In the first 3 minutes after the power cord is plugged
in, the unit will check room air condition and save
it in memory. During the time, the "Air Sensor"
indicator and "Humidity Level 50" indicator will blink.
You may start the operation in less than 3 minutes
after plugging. In this case too, the "Air Sensor" and
"Humidity Level 50" indicators will continue to blink.
After 3 minutes, the indicators will stop to blink and
show the level of air contamination and humidity.
Blink
The "Air Purify" mode indicator is lit in green. *
(Orange)
Lit in green
Note
If On/Off button is not pressed after plugging the power
cord, all indicators will go off after the "Air Sensor" and
"Humidity Level 50" indicators blink for 3 minutes.
(Remote controller operation is accepted even in
this state.)
On/Off
(Approx.)
Clean
Max(Blinking)
Air Humidifying
Sensor Filter
Blink
P.E-14