Playback Sound - JVC GR-DVF10U Instructions Manual

Playback Sound

During playback, the camcorder detects the sound mode in which the recording was made, and plays the
sound back. Select the type of sound to accompany your playback picture. (32 kHz is preset to "SOUND 1"
and 48 kHz is preset to "FULL SOUND".)
Recording sound
32 kHz
48 kHz
When watching a tape recorded at 32 kHz, if you want to change the output sound, access the Playback Menu
and, in step 3 on page 40, select "32 kHz MODE" and set it for "FULL SOUND", "SOUND 1" or "SOUND 2".
When playing back a tape recorded at 48kHz, set in the same manner. For information on output sound during
Audio Dubbing, see page 57.
NOTES:
You can also use the provided RM-V712U remote control's AUDIO MONITOR button to change the output
sound (without having to access the Playback Menu). Make sure you point the remote control at the
camcorder's remote sensor.
During playback, the camcorder detects the sound mode in which the recording was made. This detection
cannot be made during fast-forward or rewind. During playback the sound mode is displayed in the upper
left corner.
Display
DEC 25 ' 98
TC 12 : 34 : 24 PM 5 : 30
25 . 12 . 99
TC 12 : 34 : 24
Display
FULL SOUND
SOUND 1
SOUND 2
FULL SOUND
SOUND 1
SOUND 2
Minutes
Seconds
Frames*
*25 frames = 1 second
16 : 40
Output sound
Stereo sound
Stereo sound
"L" sound is output on both channels
"R" sound is output on both channels
TIME CODE
(Displaying The Time Code During Playback)
You can display the Time Code on screen during playback.
This is especially useful for editing. This function is preset
to "OFF". To turn it on, select "TIME CODE" at the
Playback Menu and change the setting (
ON– The Time Code is displayed on the playback screen.
OFF– The Time Code does not appear.
DISPLAY
(Displaying the Date During Playback)
If the time has been set, the date is automatically recorded
separately from the recorded video signal. You can display
or remove the date anytime during playback. This function
is preset to "ON". To turn it off, select "DISPLAY" at the
Playback Menu and change the setting (
ON– The date is displayed on the playback screen.
OFF– The date is not displayed.
41
EN
pg. 40).
pg. 40).