JVC GR-DVF10U Instructions Manual page 59

SYMPTOM
11. Snapshot mode cannot be
used.
12. Digital Zoom does not
work.
13. Programme AE with
special effects and Fade/
Wipe Effects do not work.
14. The Black & White Fader
does not work.
15. The Dissolve function does
not work.
16. Scene transition does not
go as expected.
17. The Picture Wipe and
Dissolve functions do not
work.
POSSIBLE CAUSES
11. •The Squeeze mode is
selected.
12. •16X optical zoom is selected.
•Picture Wipe or Dissolve are
being used in a scene
transition.
•Snapshot was attempted
during Digital Zoom.
13. •The Power Switch is set to
"AUTO".
14. •The Sepia or Monotone
mode is activated.
15. •The Sepia, Monotone or Slow
Shutter mode of Programme
AE with special effects is
activated.
•The Squeeze mode is
selected.
•The previously selected mode
of Programme AE with
special effects was changed
after the last selected scene
for editing was registered.
16. •When using "Picture Wipe/
Dissolve" ( pg. 28), there is
a delay of a fraction of a
second between the previous
record stop-point and the
Dissolve start-point. This is
normal, but this slight delay
becomes especially notice-
able when shooting fast-
moving subject or during
rapid panning.
17. •The last selected editing
scene is ending.
•At the end of the last selected
scene for editing, the Power
Switch was set to "OFF".
•The power is off.
CORRECTIVE ACTION
11. • Disengage the Squeeze
mode ( pg. 25).
12. • Wait until the Picture Wipe
or Dissolve effects are
completed ( pg. 28).
• Do not attempt to take a
Snapshot when performing
Digital Zoom (
13. • Set the Power Switch to
"PRO." ( pg. 27, 30).
14. • Turn off Sepia and Mono-
tone ( pg. 30).
15. • Turn off Sepia, Monotone or
Slow before adding Dissolve
to a scene transition
( pg. 30).
• Make sure that the Squeeze
mode in the Recording
Menu is set to "OFF"
( pg. 24).
• Make sure you have selected
the mode of Programme AE
with special effects you want
before starting editing
( pg. 30).
16.
————
17. • Select Picture Wipe or
Dissolve before beginning
recording. The effects are
then automatically activated
( pg. 28).
• Do not turn off the
camcorder's power after
setting Edit-In and Edit-Out
points, as they will all be
erased (
pg. 28).
• The camcorder automati-
cally shuts off after 5
minutes have elapsed in the
Record-Standby mode.
Make sure you continue
operations within 5 minutes
after engaging Record-
Standby mode (
CONTINUED ON NEXT PAGE
59
EN
pg. 22, 23).
pg. 28).