Table of Contents
Advertisement
4036-307, -308
Disk Encryption
If a hard disk is installed, Disk Encryption selects whether the data on the disk is encrypted or not. The values
are Disable and Enable.
This setting determines if the printer encrypts the information that it writes to the hard disk. The values are
Disable and Enable.
Warning: If the value is changed from Enable to Disable or from Disable to Enable, then the printer completely
formats the hard disk. All information on the disk will be unrecoverable.
To change this setting:
1.
Touch
Note: If an advanced password has been established, you must enter this password in order to change
the setting. If no advanced password exists, you can establish one by using the keyboard that appears on
the LCD.
2.
Touch
If you remove an encrypted disk from a device and then try to install another disk, Disk Corrupted.
Reformat? appears on the LCD. You can format the newly installed disk, or remove it from the device.
3.
Contents will be lost. Continue? appears on the touchscreen. Touch No to cancel or Yes to
proceed. If you select Yes, the printer performs the selected action on the hard disk. The following graphic
appears when the encryption process is selected:
The panel provides many progress indicators during the two-stage process.
•
1/2 indicates that the process is currently in the first stage.
•
0% indicates the progress of the current stage of the process.
•
The progress bar indicates the overall completion of the entire process by filling in throughout each
separate stage.
3-10
Service Manual
to select Disk Encryption from the Configuration Menu.
next to either Enable or Disable.
Advertisement
Table of Contents
