Toshiba 730CDT Maintenance Manual page 164

4.13 FL Inverter Cable
Removing the FL Inverter Cable
To remove the FL inverter cable, follow the steps below and refer to Figure 4-30.
1. Turn off the power to the computer, then disconnect the AC adapter and all
external cables connected to the computer.
2. Remove the battery pack, optional memory module, optional PC card, upper
cover, display mask, FL Inverter board, and LCD module as described in sections
4.2, 4.3, 4.4, 4.10, 4.11, and 4.12.
3. Remove two M2.5x6 screws securing two ground cables to the right hinge.
4. Remove one M2.5x6 screw securing one ground cable to the left hinge.
5. Remove one M2.5x6 ground screw in the top cover cable channel and
disconnect the FL Inverter cable from PJ703 on the IPS board.
6. Remove the tape from the back cover and covering the cable, and lift out the FL
inverter cable.
4-34
Figure 4-30 Removing the ground cable screws
730CDT