Toshiba 730CDT Maintenance Manual page 148

Installing the CD-ROM Drive
To install the CD-ROM drive, follow the steps below and refer to Figures 4-14 back through
4-11.
1. Seat the cable cover (be sure the cable cover is between the connector and the
drive), then connect the cable connector.
2. Replace the connector cover.
3. Push the CD-ROM drive fully into the frame.
4. Secure the frame to the drive with four M2x3 silver screws and two M2.5x6
silver screws.
5. Turn the computer upside down.
6. Insert the CD-ROM drive in the computer and press gently until it locks into place
(make sure the LED indicator cover is in the up position).
7. Close the LED indicator cover.
8. Slide the cover to the right to engage the latches.
9. Install the optional PC card, optional memory module, and battery pack as
described in Sections 4.4, 4.3, and 4.2.
4-18
Figure 4-14 Installing the CD-ROM drive
730CDT