Toshiba 730CDT Maintenance Manual page 127

NOTE: If the setting for the Modem port is the same as that for the serial
or infrared port, the serial or infrared port is automatically set to disabled.
(d) Parallel Port
This option sets the address for the parallel port. When the Printer Port
Type is set to Standard Bi-directional (see the settings below), options
include:
When the Printer Port Type (see settings below) is set to ECP, the DMA
channel can also be set to 1, 2 or 3. The default is 3.
When you select one of these options (except for Not used), a subwindow
similar to the one below displays allowing you to set the parallel port mode.
The options for this setting are ECP (default) and Standard Bi-Directional.
For most printers, the port should be set to ECP. With other parallel de-
vices, the setting should be Standard Bi-Directional.
730CDT
LPT setting Interrupt level
LPT 1 7
LPT 2 5
LPT 3 7
Not Used
Others (Others settings are made automatically by plug-and-
play operating systems)
LPT setting Interrupt level
LPT 1 7
LPT 2 5
LPT 3 7
Not Used
Others (Others settings are made automatically by plug-and-
play operating systems)
Options
Mode =
DMA =
I/O address
378H
278H
3BCH
(Parallel port default)
I/O address
378H
278H
3BCH
(Parallel port default)
ECP
Channel 3
DMA Channel
3 (Default)
3
3
3-69