Toshiba 730CDT Maintenance Manual page 110

(c) Remove the Diagnostics Disk from the FDD, insert the source disk, and
press any key. The following message displays, indicating the program has
started:
[ FDD TYPE ] : TRACK
[ FDD TYPE ] : HEAD
[ FDD TYPE ] : SECTOR = XX
Copy start
(d) Remove the source disk from the FDD, insert a formatted work disk, and
press any key. The [[ track, head
displays and starts copying to the target disk. If the amount of data is too
large to be copied in one operation, the message from step (b) is displayed
again. After the floppy disk has been copied, the following message dis-
plays:
Copy complete
Another copy (1:Yes/2:No) ?
(e) To copy another disk, type 1 and the message from step (a) will be displayed
again. Entering 2 returns the test program to the DIAGNOSTIC menu.
4. DUMP program
(a) When DUMP is selected, the following message displays:
DIAGNOSTICS-HARD DISK & FLOPPY DISK DUMP : VX.XX
Drive type select (1:FDD, 2:HDD) ?
(b) Select a format type. If 1 is selected in step (a), the following message
displays:
Select drive number
Select an FDD drive number. The display will go to step (c).
If 2 is selected, the following message displays:
Select drive number
After selecting the HDD, the display will go to step (f).
(c) The following message displays:
Format type select (1:2DD, 2:2D, 3:2HD) ?
(d) Select a format type. The following message displays:
3-52
= XXX
= X
[[ track,head =
XXX X ]] message
=
(1:A, 2:B) ?
(1:C, 2:D) ?
XXX X ]]
730CDT