Toshiba 730CDT Maintenance Manual page 138

4.3 Optional Memory Module
Removing an Optional Memory Module
To remove an optional memory module, make sure the computer is in boot mode, then follow
the steps below and refer to Figures 4-2 and 4-3.
1. Turn off the power to the computer, then disconnect the AC adapter and all
external cables connected to the computer.
2. Remove the battery pack as described in Section 4.2.
3. Remove two M2x3 silver screws securing the memory slot cover and lift off the
cover.
4. Remove two M2x10 screws securing the memory module to a brace at the center
of the module.
5. Grasp the memory card on the right edge toward the connector, or if a plastic tab
is present, lift up on the plastic tab to disengage the connectors, then grasp the
module by the edges and remove it.
4-8
Figure 4-2 Removing the memory module cover
730CDT