Table of Contents
Advertisement
Configuration
Setting the Radio Link
The Base Station and Rover require the following same radio
configuration settings to properly communicate:
• Current frequency
• Signal Threshold Level
• Free Channel Scan
NOTICE
NOTICE
The default settings for radio configuration should be
sufficient for most jobsites. Changing these settings can
affect the operation of the radio modem and
communication between receivers.
The Radio Link tab (Figure 2-20 on page 2-29) has settings for
establishing a link between the Base Station and Rover. Use the
following table to determine the settings for the Base and Rover
receivers (Table 2-3).
Radio Link Settings
Current Frequency
Output Power
Signal Threshold Power
Free Channel Scan
2-28
Table 2-3. Radio Link Tab Settings
Optimal Scenario
(~100m between
receivers)
Base and Rover on same
frequency.
Base at 10.
Rover at 10.
Base and Rover at -112.
Base and Rover on same
setting.
Maximum Distance
Scenario (~3–4km
between receivers)
Base and Rover on same
frequency.
Base at 1000.
Rover at 10.
Base and Rover at -112.
Base and Rover on same
setting.
HiPer Pro Operator's Manual
Advertisement
Table of Contents
