Using Minter To Clear Nvram; Using Pc-Cdu To Clear Nvram - Topcon HiPer Pro Operator's Manual

Operation
In addition, the NVRAM keeps information about the receiver file
system. Note that after clearing the NVRAM, the receiver's STAT
LED will flash orange for a few seconds indicating that the receiver is
scanning and checking the file system. Firmware versions 2.2p1 or
higher keep the spread spectrum modem on after clearing the
NVRAM.

Using MINTER to Clear NVRAM

1. Press the power key to turn off the receiver.
2. Press and hold the FN key.
3. Press and hold the power key for about one second. Release the
power key while continuing to hold the FN key.
4. Wait until the STAT and REC LEDs are green
5. Wait until the STAT and REC LEDs blink orange.
6. Release the FN key while the STAT and REC LEDs blink orange.

Using PC-CDU to Clear NVRAM

1. Connect your receiver and computer. See "Connecting the
Receiver and a Computer" on page 2-10 for this procedure.
2. Click Tools Clear NVRAM (Figure 4-12). The REC LED
flashes green and red; the STAT LED flashes red.
The receiver automatically disconnects when finished.
4-18
Figure 4-12. Clear NVRAM with PC-CDU
HiPer Pro Operator's Manual